Tips on re-installing shifter linkage?
Posted: Sat Nov 14, 2020 1:49 am
I have had a crack at changing the selector shaft seal and am struggling to get the linkage back into the hole at the bottom of the gearbox.
Could anyone describe the exact process to re-install it?
What gear should i be in?
Do i assemble the part in the photo prior to fitting it up (2 springs, small ball bearing) ?
I have been trying for hours to get this thing back in to no avail, any help would be much appreciated!
Could anyone describe the exact process to re-install it?
What gear should i be in?
Do i assemble the part in the photo prior to fitting it up (2 springs, small ball bearing) ?
I have been trying for hours to get this thing back in to no avail, any help would be much appreciated!
