Page 1 of 1
carry exhuast
Posted: Tue May 11, 2010 1:25 am
by supervan
why is there to little pipes that start from the end of the header pipes that go for about 30 cm and then they run into the cat and then the exhuast starts from there. whats the go with that ive never seen anything like it befor. its like ive got a twin 1 inch exhuast for 30cm into a single pipe what tha.........
Posted: Tue May 11, 2010 6:34 pm
by gadj
Just another way to produce a "factory" header/extractor. You will find most extractors have 3 stages - primary from the exh. port, secondary from primaries & the secondaries join into the final exhaust tube. Assuming yours is a four cyl. two cyls will lead into each of the two 1" pipes (secondaries) which join at the cat.
Many cars were produced with cast primary stage & formed tube secondary stage like yours. The first I saw was in the early four cyl Torana sports model.
Posted: Tue May 11, 2010 7:35 pm
by Brayden
Swift exhaust system is the same style.
Posted: Tue May 11, 2010 8:10 pm
by supervan
ok well that ansers that then.
Posted: Tue May 11, 2010 8:16 pm
by supervan
Brayden wrote:Swift exhaust system is the same style.
i assume you mean the 4 cyl swift. as my 3 pot swift exhaust is nothing like it.
Posted: Tue May 11, 2010 11:26 pm
by Brayden
Sorry, yes 4 cylinder models.
