Posted: Fri Jul 16, 2010 6:35 pm
Kei Spec. PM sent
Page 5 of 7
Posted: Sat Jul 17, 2010 12:47 pm
i have attached some of the requested pics, more to come
Posted: Sun Jul 18, 2010 6:59 pm
Posted: Mon Jul 19, 2010 12:27 am
heidi just showed up with the bars, cheers mate.
she accidentally handed over too much money and kei_spec rang her to come back for it. much respect goes his way
she accidentally handed over too much money and kei_spec rang her to come back for it. much respect goes his way
Posted: Wed Jul 21, 2010 6:35 pm
Prices updated, will now separate engine and box
Posted: Wed Jul 21, 2010 10:21 pm
Fitted the steering wheel today aty lunch, looks great, cheers Mark 
Posted: Wed Jul 21, 2010 10:57 pm
are they 4wd box's or just front wheel drive?
Posted: Thu Jul 22, 2010 10:28 am
The boxes are f6a FWD, i have modified a alto shifter to fit one of them so whoever buys the first box gets the shifter setup and i will throw in a nearly new clutch cable and the starter motor to suit.
Posted: Thu Jul 22, 2010 7:39 pm
so anyone know if it would bolt to an F8b? i think it will just wantin to confirm
Posted: Thu Jul 22, 2010 9:00 pm
Going by what i read yes with custom shafts, gearbox mount, linkages, f6a flywheel and clutch.
Posted: Thu Jul 22, 2010 9:09 pm
the shafts have female inners, my custom shafts are the same length as 87 alto so if alto shafts fit a mb???,then my shafts will fit
can supply flywheel and clutch to suit for $50
can supply flywheel and clutch to suit for $50
Posted: Sun Jul 25, 2010 6:12 pm
UPDATE2X tiny tdo4 turbos off mitsubishi gto 3000gt (probably good for 800cc-1.5ltr engine??) 3 bolt turbine housing flange, dump pipe included.
$175 each
Chevoit 14"x6" rims with 175/65/14+ 185/65/14 tyres 4x114.3 stud pattern $180 set.
$175 each
Chevoit 14"x6" rims with 175/65/14+ 185/65/14 tyres 4x114.3 stud pattern $180 set.
Posted: Sun Jul 25, 2010 8:36 pm
PM sent
Posted: Sun Jul 25, 2010 10:54 pm
what is the the bolt spacing on the exhaust flange on the td03's????
Also i'm assuming they are the 9b's not the 13g's???
Also i'm assuming they are the 9b's not the 13g's???
Posted: Sun Jul 25, 2010 11:42 pm
dont know what size exhaust housing, looks pretty small. bolt spacing is uneven 52mm,62mm,65mm. compressor housing inlet 35mm
