Page 1 of 1
2010 Alto engine
Posted: Mon May 13, 2013 11:54 am
by westyboy22
Hi guys can anyone let me know if a 2010 Alto engine would fit into the the MB and if so the difficulty of the task.
Westy
Re: 2010 Alto engine
Posted: Mon May 13, 2013 1:56 pm
by ssc87
Not a chance almost as wide as the g13b. I checked.
Re: 2010 Alto engine
Posted: Mon May 13, 2013 7:06 pm
by Brayden
As above. Alto gearbox is huge.
Re: 2010 Alto engine
Posted: Thu May 16, 2013 9:23 pm
by Breyten
If I remember the measurements came up as a few mm within, but you would still need to allow for vibration, which it would not.
Needs as much modification as the G13B. So it IS doable, just not yet worth doing.
I looked at it, but have lined up a G10A instead.
Re: 2010 Alto engine
Posted: Wed May 22, 2013 10:04 am
by cozza
not to mention it being too tall no matter how you lean the engine over it would never fit. the new alto engines are same in size as the new swift just different cc's
Re: 2010 Alto engine
Posted: Wed May 22, 2013 1:33 pm
by Breyten
Didn't think it was much taller than the F8C, and then it was all the plastics on top that you'd customize anyhow?
Re: 2010 Alto engine
Posted: Tue May 20, 2014 1:20 pm
by westyboy22
Cheers for the reply's I will keep hunting!