So I read the DIY guide and orderd up a crane came xr700
But when I went to look over it my coil set up seems to be in a mess.
Like I have 2 ballast resistors and some other stuff going on. Can I remove all this and replace with a su12 coil and just one of the resistors?
See pic
Dropping resistor wasn't used in my set up just ran the su12 transformer coil straight 12v and its been sweet, those aftermarket dropping resistors in your set pic looks like the used a different coil at some stage to the factory 3 pin type. Which have different internal resistance
I have a two pin coil on it just now is that the wrong coil then? It's had it on for two years now haha
So can I just use the two pin coil already on the car for the conversion just without the resistors?
i got a su12 exactly like in the link, but it wont fire with it on,
i mean it sparks at the plugs but the engine just cranks like theres nothing
old coil back on and it fires again, su12 back on and still nothing...
blody cars eh