I need as many torque settings for a 89 alto works rs/r as possible
Things like front crossmember, front engine mount to crossmember, front swaybar to crossmember
front strut - top, and to hub
driveshaft castle bolts
brake disc to hub bolts
Torque Settings wanted
- Goofy[HSK]
- Posts: 630
- Joined: Tue Nov 15, 2005 9:33 pm
- Location: South Australia
- Contact:
'89 Alto Works RS/R - Awaiting: Paint, Windscreen, Compliance, Lottery
'89 Alto Works RS/R - Complied, Registrable, Awaiting Paint, Engine not running
www.hillsidekonnection.com
'89 Alto Works RS/R - Complied, Registrable, Awaiting Paint, Engine not running
www.hillsidekonnection.com
I'll give you the settings for a Hatch/MB, which should be similar, if not exactly the same.
In N.m
Subframe = 40-60
Engine mounts = 23-28
Strut bolts top = 18-28
Strut to hub = 70-90
Driveshaft castle = 150-270
No listing for discs.
The full torque settings are in the Hatch manual available in the TAMON guides section.
In N.m
Subframe = 40-60
Engine mounts = 23-28
Strut bolts top = 18-28
Strut to hub = 70-90
Driveshaft castle = 150-270
No listing for discs.
The full torque settings are in the Hatch manual available in the TAMON guides section.
F8B EFI turbo - Three pots and a snail.
- Goofy[HSK]
- Posts: 630
- Joined: Tue Nov 15, 2005 9:33 pm
- Location: South Australia
- Contact:
ta, realised I had them after I posted, i'd assume they'd be the same or similar as mine
'89 Alto Works RS/R - Awaiting: Paint, Windscreen, Compliance, Lottery
'89 Alto Works RS/R - Complied, Registrable, Awaiting Paint, Engine not running
www.hillsidekonnection.com
'89 Alto Works RS/R - Complied, Registrable, Awaiting Paint, Engine not running
www.hillsidekonnection.com