extractor parts

[kidwithahatch]

hey does anyone have a rough idea on how much it would cost to get just the pipes bent for extractors, not the whole system made up??

[qbucket]

you may be able to use some motor cycle pipes ? old header pipes of some 3or4 into 1's ect ? the collector is the hard part , make a flange to bolt to head from some flat bar and weld them on , could be done , but you would not want to pay any one to do it , to many $ , look around the junk yards ect , can you weld ?

[kidwithahatch]

umm not really but am gunna start learning pretty soon. pretty keen to learn even if it is only basic skills

[Brayden]

Best thing to use for extractors are mandrel bends. Crush/press bent pipes aren't nearly as good.

[gadj]

Mandrel bends can be bought at the exhaust shop & some parts outlets. you may even be able to acquire the manifold plate ready cut.