Page 1 of 1
tension figures
Posted: Sat Aug 01, 2009 10:32 pm
by falcon
Can anyone give me tension figures on a f6a engine,rebuilding gillys alto works i got off him.Had a cracked valve.plus i`m boring it out,if the boys from minibrutes can get the right pistons.cheers
Posted: Sun Aug 02, 2009 2:44 pm
by gadj
Figures & tensioning sequence should be supplied with gasket sets - or at least be provided on gasket makers site or catalogue.
You may need to talk to an engine rebuild shop - possibly overseas to get all figures. ( email Suzuki?)
Posted: Tue Aug 04, 2009 12:26 pm
by ToranaGuy
I've not known gaskits that require certain tensions to not come with a set of tensions on a sheet of paper, and even the tightening sequence.
Were your gaskits missing this info?
Cheers
ToranaGuy